Machine Tender/Metal Finisher (1st Shift)

Responsibilities: Pull finished laser cut parts from the load tables and stack on carts. Operate hand/air tools and electric grinders. Verify part counts to the number of parts nested by the laser programmer. Locate parts that have fallen to the ground through the table grates. Accurately complete the Work Order paperwork. Attach applicable part tags. Move laser cut parts to the correct locations based on the next operation as dictated on the Job Travelers. Empty the slag pans daily. Clean the floor under the load table daily at specified time(s).Complete daily 5S requirements. Clean the lasers weekly. Assist in other duties as requested by trainer, manager or supervisor.

Education and Experience: High school or general education degree (GED).Machine shop experience is a plus.

Skills and Abilities: Read and interpret documents such as safety rules, operating and maintenance instructions, and procedure manuals. Complete standardized written documentation and correspondence. Professionally communicate in one-on-one and small group situations. Ability to perform basic electronic tasks using computer software and Microsoft Office.

Working Conditions/Physical Demands: Environment is a modern production facility with heat and air conditioning. While performing the duties of this job, the employee is generally required to stand; use hands and fingers to manipulate raw materials, finished parts and cutting tools. Ability to twist at the waist 180 degrees (side to side) repetitively. Ability to squat/bend and lift up to 15 pounds to place parts on machine at chest level repetitively. Ability to lift 16 to 50 pounds occasionally. Ability to squat and lift up to 75 pound fixtures to place on machine at chest level occasionally, with assistance. Ability to reach over head with one arm to adjust setup dial regularly.