Staff Hardware Engineer

Responsibilities: Own board design end‑to‑end: requirements, architecture, component selection, schematics, layout constraints, DFM/DFT, prototyping, and release to manufacturing. Design multi‑layer, high‑density PCBs: impedance‑controlled routing, length matching, differential pairs, HDI (blind/buried vias), fine‑pitch/BGA packages. Build embedded platforms: microcontrollers/SoCs, memory (DDR/LPDDR), power delivery (PMICs, DC‑DCs, sequencing), peripherals and sensors. High‑speed I/O: architect and validate PCIe, USB 3.x, Ethernet, MIPI, LVDS, I2C, SPI, UART, CAN.Bring‑up & debug: lead hardware bring‑up with firmware; isolate issues using oscilloscopes, logic/spectrum analyzers, power analyzers, JTAG/SWD, and boundary‑scan. Verification (EVT/DVT/PVT): create and execute test plans for functionality, SI/PI, power/thermal, environmental and reliability; document results and drive fixes/ECOs. Optimize performance: analyze CPU, memory, I/O, and power budgets; tune for power consumption, thermal efficiency, stability, and cost. Compliance & quality: design for EMI/EMC and safety; coordinate pre‑scan and certification (e.g., FCC/CE/UL); ensure RoHS/REACH compliance. Manufacturing collaboration: work with CMs/EMS partners on stack‑ups, build reviews, test fixtures, yield improvements, and FA/RMA resolution. Technical leadership: run design reviews, mentor engineers, manage risks/schedules, and maintain crisp documentation in PLM/requirements tools.

Required Qualifications: 5+ years of board‑level hardware design experience shipping products (or equivalent).Proficiency with ECAD tools (Altium Designer, Cadence OrCAD/Allegro, or KiCad) and strong schematic/layout fundamentals. Proven experience with embedded system hardware (MCUs/SoCs, memory, PMICs) and low‑power techniques for battery‑ or energy‑constrained devices. Solid grounding in signal and power integrity, impedance control, termination, decoupling, and clocking. Hands‑on lab skills for bring‑up, validation, and root‑cause analysis using standard bench equipment. Ability to write clear test plans, reports, and release documentation; fluency with ECOs and design controls. Effective collaboration with firmware, software, mechanical, thermal, and manufacturing teams. BS/MS in Electrical or Computer Engineering (or equivalent practical experience).

Preferred Qualifications: FPGA/CPLD experience (Verilog/VHDL).SI/PI and thermal simulation tools (e.g., HyperLynx, Sigrity, LTspice) and EMI/EMC mitigation techniques. Regulatory and reliability testing (e.g., IEC 62368, FCC Part 15, ESD IEC 61000‑4‑2, HALT/HASS).DFM/DFT/ATE, boundary‑scan (IEEE 1149.1/1149.6), ICT/flying probe, and functional test fixture development. Supply chain awareness: lifecycle/ALT sourcing, risk management, and cost optimization. Thermal management (heat‑sinks, airflow, interface materials, simulation).Linux/RTOS bring‑up familiarity and common boot/debug flows. Experience with PLM (e.g., Arena/Agile) and version control (e.g., Git).